Husqvarna TC 242TX Bedienungsanweisung Seite 28

Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove the
battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with a
wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
page 15 .
To replace the battery
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
1. Find the silver ground screw (A) on the right side
plate of the product, above the right rear tire.
D
B
A C
2. Use a 1/2 in. (13 mm) wrench or socket to remove
the silver ground screw. Do not discard the silver
ground screw.
3. Pull the protective sleeve (B) away from the terminal
end (C) on the black (negative) battery cable.
4. Use a 7/16 in. (11 mm) wrench or socket to remove
the larger red (positive) battery cable (D) from the
starter solenoid.
Note:
Do not remove the smaller red wire from the
wire harness on the solenoid valve.
28
To connect the battery on
Risk of electrical shock and
5. From behind the product, open the battery door (E)
and remove the battery door support (F) from battery
door holders (G).
K
J
6. Put the battery door support in the slot (H) below the
battery door.
7. Pull the battery (I), with the 2 cables attached, out of
the battery compartment.
8. Put the battery on the battery door.
9. Disconnect the black (negative) battery cable (J),
remove the bolt and nut.
10. Disconnect the red (positive) battery cable (K),
remove the bolt and nut.
11. Carefully remove the battery from the product.
12. Install a new battery.
13. Connect the red (positive) battery cable (L) with the
bolt (M) and the square nut (N).
N
L
M
14. Connect the black (negative) battery cable with the
bolt and the square nut.
15. Close the battery door and lock it with the battery
door support in the battery door holders.
G
I
F
H
1923 - 005 - 13.10.2022
E