Hour Meter; Product Liability - Husqvarna TC 242TX Bedienungsanweisung

Slope risk. Do not operate the product
straight up a slope that is more then 15°.
Slope risk. Do not operate horizontally on
a slope.
Slope risk. Do not operate the product
straight down a slope that is more than
15°.
The hot surfaces symbol show a risk,
which, if not obeyed, can cause death,
serious injury and/or damage.
The fire symbol shows a risk, which, if not
obeyed, can cause death, serious injury
and/or damage.
Sound power level.
The product agrees with the applicable
EC directives.
This product conforms to the applicable
UK regulations.
1923 - 005 - 13.10.2022
Cruise control.
Freewheel (automatic models only).

Hour meter

The hour meter shows how many hours the engine has
been in operation. Refer to
for the position of the hour meter.
Each 50 hours an oil level symbol will show for 2 hours.
Lubrication schedule on page 24 .
Refer to
To manually reset the hour meter, turn the ignition key to
the on position and then to the "STOP" position 5 times.
Note:
The hour meter only stops when the ignition key
is in the "STOP" position. Make sure that the ignition
key stays in the "STOP" position when the engine has
stopped.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Euro V Emissions
WARNING:
voids the EU type-approval of this product.
Product overview on page 3
Tampering with the engine
5