Zibro PX 738 Bedienungsanleitung Seite 79

All manuals and user guides at all-guides.com
5 Put the isolation material around the connectors / tubing again.
Close the cabinet cover for quick connector shielding µ.
6
7 Store the protection caps
WARNING
After connecting the refrigerant tubes, take care that these are well
isolated again. If this is not done properly, damage because of
condensation water can occur!
H
MAINTENANCE
ATTENTION!
Switch off the device and pull the plug out of the socket before you
clean the device or filter or when you replace the filters.
Use a soft, damp cloth for the regular cleaning of the exterior of the device. Never
use aggressive cleaning agents, solvents, benzene or abrasives. Refer to chapter D
"Air Filter" for filter maintenance.
NOTE!
Never use the device without the mesh filter.
I
STORAGE
1 Empty the water reservoir (see chapter F).
2 Clean the mesh filter (see chapter D).
• Remove the 3M™ Filtrete™ filter and active carbon filter before seasonal
storage and install new filters at the beginning of the new season. The
old filters can be disposed in the 'Non-biological garbage container'.
• New filters are available at your dealer.
3 Switch the device to air circulation mode for several hours. This will
completely dry out the interior.
4 Protect against dust and store in a dry place that is not accessible to children.
NOTE!
Do not store the units disconnected, to prevent leakage of refrigerant.
in a safe place.
4
79