Maintenance And Storage - Stiga Park-Serie Gebrauchsanweisung

(Translation of the Original Instructions)
Do not change the engine governor set-
tings or overspeed the engine .
Do not touch engine components which
get hot during use . Burns hazard .
Disengage the cutter blade or the PTO,
set the engine to the idle position, stop
the engine and remove the key (make
sure that all moving parts have come to
a complete stop):
a . whenever you leave the machine
unattended or leave the driver'r seat.
b . before removing the jamming cause
or unclogging the collector channel;
c . before checking, cleaning or working
on machine;
d . after striking a foreign object. Inspect
the machine for damage and make
repairs before restarting and opera-
ting the machine;
Disengage the cutter blade or the PTO
and stop the engine (make sure that all
moving parts have come to a complete
stop):
a . Before refuelling;
b . Every time you remove the grass col-
lector sack or put it back on;
c . adjusting the cutting height, assuming
this operation cannot be done from
the driver's seat.
Disengage the cutting blade or the PTO
during transport or whenever the ma-
chine is not being used .
Reduce the throttle setting before stop-
ping the engine. turn the fuel off at the
conclusion of mowing, following the in-
structions in the manual .
Take care with multiple blade cutting
decks as one rotating blade may cause
other blades to rotate .
WARNING - In the event of failures or
accidents when working with the ma-
chine, stop the engine immediately
and move the machine away to avoid
causing further damage; in the event of
accidents with injuries to operators or
third parties, take the first aid measures
which are most appropriate to deal with
the situation and contact a health care
facility for the necessary treatment . Ca-
All manuals and user guides at all-guides.com
ENGLISH
refully remove any debris which could
cause damage or injury to persons or
animals if ignored .
CAUTION! The noise and vibration le-
vels shown in these instructions are
the maximum levels for use of the ma-
chine . The use of an unbalanced cutting
element, the excessive speed of move-
ment, or the absence of maintenance
have a significant influence on noise
emissions and vibrations . Consequen-
tly, it is necessary to take preventive
steps to eliminate possible damage
due to high levels of noise and stress
from vibration . Maintain the machine
well, wear ear protection devices, and
take breaks while working.
3 .4

MAINTENANCE AND STORAGE

CAUTION! - Before cleaning or doing
maintenance work, take out the ignition
key and read the relevant instructions .
Wear adequate clothing and work glo-
ves whenever your hands are at risk.
CAUTION! - Never use the machine with
worn or damaged parts. Faulty or worn-
out parts must always be replaced and
never repaired . Only use original spa-
re parts: The use or non-original and/
or incorrectly fitted parts will compro-
mise the safety of the machine, may
cause accidents or personal injuries
for which the Manufacturer is under no
circumstance liable or responsible .
Any regulations and maintenance ope-
rations not described herein must be
carried out by your Dealer or Authori-
zed Service Centre, which have the ne-
cessary knowledge and equipment to
ensure that the work is carried out cor-
rectly, maintaining the correct degree of
safety and the original operating condi-
tions of the machine. Any adjustments
or maintenance operations carried out
by people not having the necessary
knowledge will nullify the warranty and
exonerate the manufacturer from all lia-
bility .
• After each use of the machine, remove the key
and check for any damage.
EN
9