General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PBH 800 A1 Originalbetriebsanleitung

Noise emission value
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically as follows:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear hearing protection!
Total vibration value
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Hammer drilling
in concrete a = 12.604 m/s
h(HD)
Chiselling a = 13.466 m/s
h(CHeq)
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with
a standardised test procedure and can be
used for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
PBH 800 A1
L = 96.3 dB (A)
pA
K = 3 dB
L = 107.3 dB (A)
WA
K = 3 dB
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to
2 , K = 1.5 m/s 2
your mains-operated (corded) power tool or
2 , K = 1.5 m/s 2
battery-operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
b) Do not operate power tools in explosive
c) Keep children and bystanders away while

2. Electrical safety

a) Power tool plugs must match the outlet. Never
b) Avoid body contact with earthed or grounded
c) Do not expose power tools to rain or wet
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings, instructions, illust-
rations and specifications provided with this
power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury.
or dark areas invite accidents.
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
operating a power tool. Distractions can cause
you to lose control.
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
conditions. Water entering a power tool will
increase the risk of electric shock.
GB │ IE │ 3 ■