Step 3, License Plate Holder, Short Tensioning Strap, Cable Laying, Wheel Rail Cover - Eufab AMBER PLUS Bedienungsanleitung

Caution: You must tighten both knob nuts very firmly to ensure that the U-shaped bracket is flush against the U-shaped bracket
mount.
Assembly of frame holder
Open the knob nuts of the frame holder by rotating the key by 180°
clockwise (Figure 6). Hold the claw for the bicycle rack together firmly
in one hand. Rotate the knob nuts of the frame holder anti-clockwise
until the locking mechanism of the clip is extended sufficiently that the
clip can be opened. Open the clip and place it around the shaft of the
U-shaped bracket. Close the clip and push the locking mechanism down.
Rotate the knob nut clockwise to such an extent that the clip can no
longer be opened.
Result:

5.1.3 STEP 3, LICENSE PLATE HOLDER, SHORT TENSIONING STRAP, CABLE LAYING, WHEEL RAIL COVER

13 License plate holder
14 Tensioning strap, short
15 Cable tie
16 Wheel rail cover
Mounting the license plate holder
Remove the screws from the lamp mount before installing the license plate holder and then mount the license plate holder. The license plate holder must be at
the same height as the lights.
Inserting the license plate
The mounting clips (17) for securing the license plate are push-out parts in the holder.
Break out two of the clips. Slide the license plate into the holder, then push the clips into the
cut-outs (18) to secure the license plate.
Mounting the short tensioning strap
Insert the short tensioning strap from the inside to the outside below the bike holder and
then from the outside to the inside through the slots of the bike holder (Figure 11). For the
rear wheel of the bicycle, use the centre slot of the wheel holder, for the front wheel, use the
two outer slots (two tensioning straps to prevent the front wheel from turning).
Laying electrical cables
Secure the cables of the lights to the underside of the rack using the supplied cable ties (15). Make sure that the cables cannot be damaged when lowering and
raising the rack.
Attaching the wheel rail covers
Fit the wheel rail covers (16) to the rail stoppers (Figure 12).
Result:
Figure 6: Knob nut lock
Figure 8: Result of Step 2
Figure 13: Result of Step 3
Figure 7: Assembly of frame holder
Figure 9: Individual parts, Step 3
Figure 10: License plate holder
Figure 11: Tensioning strap, short
Figure 12: Wheel rail cover
11