Specifications; Standard Accessories - Hitachi DH 40MB Bedienungsanleitung

SPECIFICATIONS

Voltage (by areas)*
Power input
Capacity
No load speed
Full-load blow
Weight (without cord, side handle)
*Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case (Molded plastic) .............................................. 1
(2) Side Handle ............................................................... 1
(3) Stopper ....................................................................... 1
(4) Hexagon Bar Wrench (for 6 mm screw) ............ 1
(5) Hexagon Bar Wrench (for 5 mm screw) ............ 1
(6) Hammer Grease A ................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (SDS max shank)
Outer diameter (mm)
16
19
22
25
28
32
38
40
2. Anchor hole drilling (Rotation + Hammering)
Drill bit (Taper shank)
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 mm
Overall length (mm)
340, 540
320, 520
370, 570
(2) Taper shank
adapter
(SDS max shank)
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
950 W*
Drill bit: 40 mm
Core bit: 105 mm
180 – 360/min.
1400 – 2800/min.
6.6 kg
Taper shank
Application drill bit
adapter
Morse taper Drill bit (taper shank)
(No. 1)
11, 12.3, 12.7, 14.3, 14.5, 17.5 mm
Adapter for SDS-plus shank bit
(1) Drill bit
(SDS-plus shank)
3. Large dia. hole boring (Rotation + Hammering)
(Guide (1) Center
plate) pin
(1) Center pin
Applied to core bits from 38 mm to 105 mm
Applied to core bits 32 mm and 35 mm
NOTE
Do not use core bits 25 mm or 29 mm.
(2) Core bit
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 mm
(with guide plate, not applicable to cores 25 mm
or 29 mm)
(3) Core bit shank
Applied to core bits above 38 mm
Applied to core bits below 35 mm
4. Drilling holes .... For drilling metals and wooden
13 mm drill chuck
(13VLA)
Chuck wrench
English
(2) Adapter for SDS-plus
shank bit
(SDS max shank)
(2) Core (3) Core bit shank
bit (SDS max shank)
materials
Chuck adapter
(SDS max shank)
6