Klarstein PASSAU Bedienungsanleitung Seite 24

EN
24
5. Remove the protective cover and the beer hose of the beer keg.
6. Align the beer outlet valve device vertically with the connection part of the
beer keg in the middle of the top of the beer keg and press it into the beer
keg immediately. When you hear a click, it means that the tap valve device has
been correctly attached to the beer keg (see figure 4). Place the beer keg in
the cooling keg of the appliance after installing the valve device.
7. Plug the quick release connector at the end of the beer line on the beer valve
device into the air inlet connector. As soon as you hear a slight click, this
indicates that the connection has been successfully established (see figure 5).
4
Note: After installing the valve
device, hold the suction pipe
in the direction of the middle
groove of the two handles of the
barrel. Keep the bottom of the
cooling keg and the beer keg
free of dirt and other substances,
otherwise the cooling effect may
be impaired.
5
Air inlet connection
Air inlet socket