Safety Devices - Kalor Ermetica 98 Cast Round 10C Bedienungsanleitung

Safety devices

Pressure switch: monitors
depression in the smoke
duct. It is designed to
shut down the
feed screw in the event
of an obstructed flue or
significant back-pressure
in the presence of wind.
At the time of the pressure
switch will show "A L 0 6 A L 0 6 ".
Electrical safety:
stove is protected against
violent surges of current
(ex. lightnings) by the main
fuse 4 A which is located
on the control panel at
the rear of the stove.
Other fuses to protect the
electronic boards are to
be found on the boards
themselves.
Tampering with the safety devices is prohibited. It is only after eliminating the
cause which gave rise to the intervention of the safety system, that it is possible to
relight the stove and thus reset the automatic operation of the sensor.
16
Reduction motor: if the
motor stops, the stove
continues
pellet until the flame goes out
for lack of fuel, and until
It has cooled down to the
minimum level.
RESTART
the Pellets
safety:
event there is a too high
temperature in the tank,
the thermostat for pellets
safety with manual reset
creates an alarm "A L 0 7
stopping the pellet boiler
stove. You
need to reset the system
working on the device
placed on the back of the
stove.
to function
PELLET
temperature
In the rare
A L 0 7 "
Flue gas temperature
sensor: thermocouple that
measures the temperature
of the fumes while keeping
the operation or shuts the
stove when the flue gas
temperature drops below
the preset value.
Instruction Manual
RADIO CONTROL AND RECEIVER
Receiver
Radio control
This manual is intended for the fi nal user and
explains the operation of the radio control.
This instruction manual must be considered an
integrated part of the use and maintenance
manual and must always accompany the stove
throughout the life of the product, even in the
case of transfer to third parties.
To view the error
list, please refer to
the enclosed booklet
'Radiocontrol PDA'.
RADIO CONTROL
Cod. 001104
1