Kalor Ermetica 98 Cast Round 10C Bedienungsanleitung Seite 35

Cleaning the surfaces
To clean the surfaces, use a rag dampened with
water or with water and a neutral detergent.
The use of aggressive detergents
or thinners
surfaces of the stove. Before using
any detergent it is advisable to try it on
a small section out of sight or contact
the Authorized Assistance Centre for
information regarding the product.
Cleaning the metal parts
To clean the metal parts of the stove, use a soft
cloth dampened with water.
Never clean the metal parts with alcohol, thinners,
petrol, acetone or other degreasing substances. If
such substances are used, our company declines
any responsibility.
Eventual variations in the colour of the metal parts
can be caused by an incorrect use of the stove.
It is necessary to daily clean the
brazier and often clean the ash box.
The lack of cleanliness can prevent
the starting of the stove, causing
damages to the stove itself and to the
environment (possible emission of unbrunt
material and soot). Do not re-use the pellet
possibly remained in the brazier due to no
starting-up.
CLEANING BY THE TECHNICAL
Check every year
Clean the combustion chamber
When the stove is cold, please join the following
procedure:
1 1
can damage the
Open the door and pull
the ash tray out and
remove the brazier.
(photo 1)
Remove the mounting
of the refractory
pushing it upwards and
then pull it out from the
combustion chamber.
(photo 2)
Turn and tilt it to remove
it. (photo 3)
2 2
Now push the refractory upwards (photo 4 +
photo 5), rotate (photo 6) and remove it from the
combustion chamber.
When handling the refractory take care not to
break it, it is very fragile.
4 4
6 6
Now remove the plate located under the ash box.
To enter you must remove the sides and any panel
beneath the door of the combustion chamber.
Unscrew the screws (photo 7) and remove the
plate to have full access to the exchange tubes.
(photo 8)
3 3
5 5
7 7
13