Kalor Ermetica 98 Cast Round 10C Bedienungsanleitung Seite 26

Charge pellet
Fuel is loaded from the upper part of the stove by
opening a door.
Pour the pellets in the hopper; vacuum contains
about 20 kg of pellets. This is easier if performed
in two steps:
• Pour half of the contents of the bag into the
hopper and wait for the fuel to settle on the
bottom.
• Then pour in the second half;
• Keep the cover closed , after loading the pellets
, the lid of the fuel tank;
• Before closing the door load-pellet make sure
that there are no residues of pellets around the
seal. If carefully cleaned to avoid compromising
the seals.
The stove is a product by heating, presents the ex-
ternal surfaces particularly hot. For this reason, we
recommend extreme caution when operating in
particular:
• Do not touch the stove body and the various
components, do not approach the door , it could
cause burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come near;
Pellet
The pellets are cylinders of compressed wood, produced from sawdust and wood
processing (chips and sawdust), generally produced by sawmills and carpenters. The
binding capacity of the lignin contained in wood, allows to obtain a compact product
without adding additives and foreign chemicals to the wood, is therefore
obtained a natural fuel with high yield.
The use of expired pellets or any other unsuitable material can damage
parts of the thermostove and impair proper operation: this can lead
to the termination of the guarantee, and its producer responsibility.
For our products use pellets diameter 6 mm, length 30 mm and a maximum of 6%
A1 certified according to the UNI EN ISO 17225-2 standard. Keep the pellets away from heat
sources and not in humid environments or with explosive atmosphere.
In order to achieve the test report results, please load the performance parameters retained by
the manufacturer and the qualified technician. They will use these parameters once verified
that, during the installation, it is possible to reproduce the laboratory conditions.
4
To ensure an airtight seal must be cleaned be-
fore the bar of the door seal pellet feed.
Never remove the protection grille
in the hopper. When filling, do not
let the sack of pellets touch any
hot surfaces.
and