Kalor Ermetica 98 Cast Round 10C Bedienungsanleitung Seite 34

Maintenance and cleaning of the stove
Before effecting any maintenance operation
or cleaning on the stove, take the following
precautions:
• be sure that all parts of the stove are cold.
• be sure that the ashes are completely cold.
• be sure that the general switch is in the "OFF"
position.
• be sure that the plug is pulled out of the socket
to avoid accidental contact.
• once the maintenance phase is completed
check that everything is in order as per before the
intervention (the brazier is placed correctly).
Follow carefully
cleaning instructions. Failure to
follow these instructions could
create problems with the operation
of the stove.
Cleaning the brazier and brazier support
When the flame assumes a red colour or seems
weak, and is accompanied by black smoke, this
means that there are ash deposits or incrustations
that do not permit the correct functioning of the
stove and that must be removed. Remove the
brazier every day by simply raising it from its slot;
then clean out the ashes and eventual incrustations
that may have formed, paying particular attention
to liberating the holes by using a pointed tool (not
included with the stove).
This operation is made particularly necessary before
every lighting the first several times and above all
if using pellets that differ from those supplied by
our company. The frequency of this operation is
determined by how frequently the stove is used
and the choice of pellets.
It is also a good idea to check the brazier support,
vacuuming the eventual ash present.
12
Ash box
Open the door and
extract the ash box. Use
a vacuum to remove
all the ash deposited
within.
This operation must be
performed more or less
frequently
on the quality of the
pellets used.
Use
open the door of the
the following
combustion chamber.
After closing the door,
remove the handle.
Cleaning the glass
The glass is a self cleaning type, therefore, while
the stove is working, a veil of air is blown across its
surface to remove ash and dirt; nevertheless over
a period of several hours, a greyish patina tends to
form which should be cleaned when the stove is
next shut down. How dirty the glass becomes also
depends on the quality and quantity of pellets used.
Cleaning the glass should be done when the stove
is cold with products recommended and tested by
our company. When performing this operation,
always check that the grey seal around the glass
is in a good state; failure to check the efficiency
of this gasket can compromise the function of the
stove. Poor quality pellets can, in any case, cause
the glass to become dirty.
Cleaning the ceramic covering (if supplied)
The ceramic tiling must be cleaned with a soft dry
cloth before using a damp cloth. Use only neutral
and delicate detergents.
Do not wet and never clean the ceramic tiling with
cold water while it is hot as the thermal shock
could cause breakage!
depending
the handle to
If the glass is broken, do not attempt
to light the stove.
Be very careful because the ceramic
is very hot.