Safety Devices - Kalor Denia 14 Bedienungsanleitung

Safety devices

monitors
Pressure switch:
depression in the smoke duct.
It is designed to shut down
the pellet feed screw in the
event of an obstructed flue or
significant back-pressure in the
presence of wind. At the time of
the pressure switch will show
" " A L A R -DEP-F AIL A L A R -DEP-F AIL" " .
the stove is
Electrical safety:
protected against violent surges
of current (ex. lightnings) by the
main fuse 4 A which is located
on the control panel at the rear
of the stove. Other fuses to
protect the electronic boards
are to be found on the boards
themselves.
Tampering with the safety devices is prohibited. It is only after eliminating the cause
which gave rise to the intervention of the safety system, that it is possible to relight the stove and
thus reset the automatic operation of the sensor. To understand which anomaly has occurred, consult
this manual at paragraph relating to alarms which explains what to do based on the alarm message
the stove display.
if the motor
Reduction motor:
stops, the stove continues to
function until the flame goes
out for lack of fuel, and until
It has cooled down to the
minimum level.
RESTART
PELLET
Pellets temperature safety:
In the rare event there is a too
high temperature in the tank,
the thermostat for pellets safety
with manual reset creates
an alarm
"AL AR -SIC -FA IL
AL AR -SIC -FA IL"
stopping the pellet boiler stove.
You need to reset the system
working on the device placed
on the back of the stove
.
Flue gas temperature sensor:
thermocouple that measures
the temperature of the fumes
while keeping the operation or
shuts the stove when the flue
gas temperature drops below
the preset value.
the room
Room thermostat:
thermostat detects the present
temperature in the room. When
it detects the set temperature
on the display, the stove will go
into operation in ECO ie hold
function to save fuel.
The room thermostat should
be spread so as not to be
conditioned by the temperature
of the body stove.
page 29 of 36