Safety Notes; Battery Replacement; Disposal - clage CFX-U Gebrauchsanleitung

CFX-U FUNKTRONIC MPS ®
4. Remote control
EN
5. The display switches to the setpoint value display.
Note: For initial installation we basically recommend to change the radio channel.
In the case of an unsuccessful registration the display indicates "no" by a flashing radio
signal after 45 seconds. The remote control quits the registration process and switches
to standby mode. By pressing a key the registration process will be repeated.
Notes:
• If the power selection of power rating has not been carried out, the operation is not
possible without a registered remote control.
• With no remote control registered or without working radio connection, the instan-
taneous water heater heats to the prior selected set temperature.
• For the professional: After a reset at the water heater (refer to installing instructions,
chapter "Reinstallation") a registration is required!

Safety notes

• At malfunction of the remote control remove the batteries immediately.
• The remote control and the wall bracket should not get close to items with magnetic
strips, like credit cards etc. The built in magnets can damage the card's magnetic
strip.
• Do not expose the remote control to moisture.
• Flat batteries can leak and damage the remote control. Hence, replace flat batteries
right away as soon as battery symbol lights up in the display or the remote control
does not response after keystroke.
• When the remote control is not to be used in the long term, remove the batteries.
• After a keystroke the remote control refreshes every 10 seconds when water is flow-
ing. When the water flow stops the remote control refreshes again 3 more times.
• Without working radio connection, the appliance heats to the prior selected set
value.

Battery replacement

Replace the batteries with new AAA-batteries when the battery symbol flashes up.
• Do not use rechargeable batteries!
• Non-rechargeable batteries are not to be recharged.
• Different types of batteries or new and used batteries are not to be mixed.
• When replacing the batteries, observe the correct polarity.

Disposal

Batteries may contain environmentally hazardous substances. Therefore, used bat-
teries must be disposed of at special collecting points and not be mixed with general
household waste.
At the end of the remote control's lifetime, the batteries must be disposed of separate
from the appliance.
18