Jumper For Emergency Signal On Aux Out - LD Systems IMA 60 Bedienungsanleitung

JUMPER FOR EMERGENCY SIGNAL ON AUX OUT

In the factory settings, the EMERGENCY signal is routed via an internal jumper to the AUX OUT line output. If this setting needs to be changed, the
device must be opened and the corresponding jumper removed.
Caution:
Warning! Danger of electric shock! Dangerous voltages inside the device!
Opening the device and changing the configuration using a jumper requires specialist technical knowledge and may only be carried
out by a specially trained person! If you are not qualified to do this, never carry out such interventions yourself, but instead contact a
trained service technician.
Be careful when opening the amplifier and changing the configuration. This will avoid damage to property and persons. Follow the individual steps
in these instructions. The manufacturer takes no responsibility for damage to property and persons due to improper use.
1. Disconnect the amplifier from the mains (pull out the mains plug)!
2. Disconnect all cables from the amplifier.
3. Wait for at least one minute before opening the housing to make sure there is no longer any voltage inside!
4. Loosen and remove the two screws on each side of the amplifier
C
amplifier with a suitable tool (9 screws in total). Note the positions of the three different types of screws.
5. Pull the housing cover off the housing from behind.
D
6. Remove the jumper (marked in figure 2) from the contacts (inside back of the device).
7. Slide the housing cover onto the housing from the rear and fasten it using the previously removed screws.
Now the emergency signal of the EMERGENCY channel is no longer routed to the AUX OUT output.
A
12
A
, the four marked screws on the back
A
B
and a screw on the top of the
C
B
D
B