GE ADTS542F Sicherheitshinweise- Und Installationsanleitung Seite 6

The ADTS must be connected to the correct electrical power supply as stated, adjacent to
the power connector.
CAUTION
THERE IS A RISK OF ELECTRIC SHOCK/ELECTROCUTION IF THERE IS NOT A
PROTECTIVE EARTH IN PLACE. THE ADTS MUST, AT ALL TIMES, BE CONNECTED
TO THE SUPPLY PROTECTIVE EARTH/GROUND.
THE POWER SUPPLY CABLE AND CONNECTOR MUST BE CORRECTLY RATED
FOR THE POWER SUPPLY. ONLY USE POWER CABLES SUPPLIED BY GE
SPECIFICALLY FOR THE ADTS.
European
Green/Yellow
1.5 Fuses
The two High Breaking Capacity fuses (8) (see Figure 7), located in the holders and
mounted on the front panel, protect the unit. The fuses are connected in the live and
neutral supply circuit and are rated at: T5AH 250V.
1.6 Replacing a fuse
1. Disconnect the electrical power supply.
2. Unscrew the fuse holder cap from the front panel and remove the fuse.
3. Fit a new fuse of the correct size and rating into the fuse holder cap.
4. Secure the fuse holder cap in the front panel.
2 ADTS Touch
The ADTS Touch is used to control all required functions. The ADTS Touch can be
positioned on the ADTS or used as a hand held mobile unit via a cable or Bluetooth
wireless technology.
The ADTS Touch will have power applied when:
• Positioned (docked) (1) on a powered-on ADTS
• Using an umbilical cable connected to a powered-on ADTS
• Powered from its own battery pack
• Powered from a universal power supply unit
[EN] English
Colour
Brown
Blue
US Colour
Black
White
Green
6
Function
Live
Neutral
Protective Earth
(Ground)
K0554 Revision B
®