GE ADTS542F Sicherheitshinweise- Und Installationsanleitung Seite 13

Hoses (available as orderable accessories on the datasheet) are used for connection to
the "Pitot" (Pt) (1) and "Static" (Ps) (2) output ports of the ADTS.
The "Pitot" (Pt) and "Static" (Ps) outputs can then be connected to the corresponding Pitot
and Static connectors on the aircraft or aeronautical instruments.
The maximum Pt and Ps output pressure is 2bar absolute.
The following table details the possible connector specifications:
G1/8
AN3
AN4
AN6
Mating female parts are available from GE.
3.4 Cleaning
CAUTION
DO NOT USE SOLVENTS TO CLEAN THIS EQUIPMENT.
The following materials are approved cleaning agents:
Note: Equivalent alternatives may be used for listed items.
1. Clean the external surfaces of the unit using lint-free cloth and a soft brush. Remove
stubborn dirt using a damp cloth and mild detergent and allow to dry.
2. Clean the electrical connector using a soft brush. Remove stubborn dirt using a damp
cloth and mild detergent and allow to dry.
4 Product labelling
The product label for the base unit can be found in the bottom right hand corner of the
front panel. The product label for the ADTS Touch can be found on the rear of the ADTS
Touch.
Labelling information consists of:
1. Company logo and product name
2. Part number
3. Serial number
4. Date of manufacture (DOM)
5. Name and address of manufacturer
K0554 Revision B
Pipe Thread ISO 228 - G 1/8 B
3/8 - 24 UNJF - 3A Thread
7/16 - 20 UNJF - 3A Thread
9/16 - 18 UNJF - 3A Thread
Material
Lint-free cloth
Damp cloth
Mild detergent
Soft brush
Specification
Commercially available
Commercially available
Commercially available
13
-
[EN] English