ANYcUBIC Photon Mono Benutzerhandbuch Seite 40

Automatic support adding skills (improve print success rate)
Tip 1: Properly increasing the support angle and density can optimize the support
results and deliver better print quality.
When browsing on the model, by observing the contour circle, it can be found that the
model still has some weak points that have not been added supports properly
(highlighted by red arrows)
If we increase the automatic support angle and support density (highlighted by red square),
we can see from the picture below that more supports have been added to some of the
weak points.
Tip 2: Manual support after Auto support (use the contour to find the weak points, add
support to the local lowest point by checking the contour circle)