ANYcUBIC Photon Mono Benutzerhandbuch Seite 15

2. Door detection function
Door detection function is disabled by default. If this function is enabled, the printer can
detect whether the lid is on or not. If the lid is removed, the printing will be paused. And
the printing will resume if put back the lid.
Click the lock icon on "Tools" interface to enable/disable this function.
3. Handling models and residues
After printing, waiting until the resin stop dropping from the platform and then unscrew
and remove the platform. The model can be removed by scrapper carefully. The
removed model should be washed with ethanol 95vol% concentration. The printed
model may need post curing to achieve better hardness by direct sunlight or UV-curing
box.
After click, the lock icon is
locked and the function is
enabled.
Funnel