Ryobi ERS-80V Bedienungsanleitung Seite 9

GB
F D
INSTRUCTIONS FOR SAFE HANDLING
CHECK DAMAGED PARTS. Before further use of
the tool, a guard or any other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting and any
other conditions that may affect its operation. A guard
or any other part that is damaged should be properly
repaired or replaced by an authorised service centre.
DO NOT USE TOOL IF SWITCH DOES NOT TURN
IT ON AND OFF. Have defective switches replaced
by authorised service centre.
DO NOT OPERATE THIS TOOL WHILE UNDER
THE INFLUENCE OF DRUGS, ALCOHOL OR ANY
MEDICATION.
THE APPLIANCE IS NOT INTENDED FOR USE BY
YOUNG OR INFIRM PERSONS WITHOUT
SUPERVISION. YOUNG CHILDREN SHOULD BE
SUPERVISED TO ENSURE THAT THEY DO NOT
PLAY WITH THE APPLIANCE.
DO NOT ABUSE THE CORD. Never carry the tool by
the cord or yank it to disconnect it from the socket.
Keep the cord away from heat, oil and sharp edges.
USE OUTDOOR EXTENSION LEADS. When tool is
used outdoors, use only extension cords intended for
outdoor use.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
SPECIFICATION
Voltage
Input
Stroke per minute
Length of stroke
Cutting Capacity (Wood)
Net weight
DESCRIPTION
1. Variable speed dial
2. Trigger switch
3. Shoe assembly
5. Blade clamp
4. Blade Lock / Release level
E I P NL
230V ~ 50Hz
800 W
0-2800 min
-1
30 mm
75 mm
2.9 kg
S DK N FIN
English
OPERATION
WARNING
Always wear safety goggles or safety glasses
with side shields when operating this tool.
Failure to do so could result in dust, shavings,
or loose particles being thrown into your eyes,
resulting in possible serious injury.
TURNING THE SAW ON/OFF (Fig. 2)
Follow these directions to turn the saw on and off:
To turn the saw on: Depress the switch trigger.
To turn the saw off: Release the switch trigger.
ADJUSTING THE SPEED (Fig. 3)
The variable speed feature allows the saw to operate at
speeds that can be increased by rotating the dial from
1 to 6. The dial is conveniently located on the handle,
allowing operator control of blade speed.
Follow these directions to adjust the speed:
To increase the speed (H): Turn the dial to a higher
setting.
To decrease the speed (L): Turn the dial to a lower
setting.
SELECTING BLADES
Selecting the correct type of blade is important in order to
obtain the best performance from your saw. Select the
blade based on the application and on the material you
wish to cut. Selecting the right blade will give you a
smoother, faster cut and prolong the life of the blade.
Blades with fewer teeth, 10 teeth per inch (TPI) are typically
used for cutting wood, while blades with more teeth are
better for cutting metal or plastic. We recommend 14 TPI
for plastics and soft metals and 18 TPI for hard metals.
INSTALLING BLADES
The toolless blade change system eliminates the need
for tools when changing the blade.
WARNING
Failure to unplug the tool could result in
accidental starting causing possible serious injury.
Follow these directions to install blades (Fig. 4):
Unplug the saw.
Lift the blade release lever.
Insert the blade fully, tooth side down.
Lower the blade release lever.
6
GR H CZ RUS RO PL