Protool CCP 380 Anweisungen Seite 27

kniha_Narex_CPP380.book Seite 27 Mittwoch, 31. Oktober 2001 11:53 11
Defects and their removal
Defect
The machine will not run
The cut is not clean, the chain
goes to the side
Required big power to shift the
machine into the cut
The chain is not lubricated
Guarantee
We guarantee appliances in accordance with sta-
tutory/country-specific regulations (proof of
purchase by invoice or delivery note).
Damages attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of compliant please send the machine, un-
dismantled, to your dealer or the Service Centre
for electric power tools.
Cause
There is no current supply
Worn brushes
Stuck switch
When overloaded
Too big shift into the cut
Blunt tool
The chain is not properly
sharpened
Cutting without a stop gui-
dance
Supporting area of the
sleigh is dirty
Blunt tool
Different qualities of wood
Too big shift for the cut
Blocked lubricating chan-
nels of the guide reglet
Defected dose oil pump
Empty oil tank
Inner oil channels of the
machine are blocked
Declare of conformity
We declare under our sole responsibility that this
product is in conformity with the following stan-
dards or standardization documents:
EN 50 144-1, EN 55 014-1, EN 55 014-2,
EN 61 000-2-3, EN 61 000-3-3,
according to the provisions of the regulations
89/336/EEC, 98/37/EC
Manfred Kirchner
Subject to change
Removal
Check safety fuses and supply
wires
Replace brushes
Press a safety fuse
Check safety fuses
Reduce the shift
Sharpen the chain, or replace it
with a new one
Replace the chain with a new one
Use the stop guidance
Clean it and lubricate it with gliding
wax
Sharpen the chain, or replace it
with a new one
Adjust the size of the shift to the
cut
Reduce the shift
Clean the guide reglet
Replace the pump (in an authori-
sed service workshop)
Replenish chain oil
Clean the machine (in an authori-
sed service workshop)
27