Floor Nozzle - Kärcher sc 1125 Betriebsanleitung

Cleaning of Glass
In case of low outside temperatures, espe-
cially in the winter, warm up the window pane
by slightly steaming the entire glass surface.
This will prevent tensions on the surface
which might lead to glass breakage.
Caution
Do not direct steam onto the sealed locations of
the window frame to prevent damage.
Steam gun
You can use the steam gun without any ad-
ditional accessories, e.g.:
to remove odours and wrinkles from
–
hanging clothes by steaming them at a
distance of 10 to 20 cm.
to remove dust from plants. Here, keep
–
a distance of 20-40 cm.
for moist dusting, by briefly steaming
–
the cloth and wiping the furniture with it.
Detail nozzle
The closer this nozzle is to the contaminat-
ed area, the higher the cleaning effect, as
the temperature and the steam are highest
at the nozzle output. Especially suited for
cleaning difficult access locations, joints,
fittings, drains, sinks, toilets, blinds and
heaters. Heavy limescale can be drenched
in vinegar prior to steam-cleaning. Let the
vinegar penetrate for about 5 minutes.
Round brush
Attach the round brush directly to the detail
nozzle. Especially well-suited for hard to
access locations, such as fittings or drains.
Caution
Not suited for the cleaning of sensitive sur-
faces.
Hand nozzle
Pull the terry cloth cover over the hand noz-
zle. Especially well-suited for small washa-
ble areas, shower stalls, mirrors or furniture
cloth material.
Application:
Windows, mirrors
–
Glass surfaces on showers
–
other smooth surfaces
–
Perform a fat dissolving basic cleaning
using the hand nozzle and a terry cloth
cover before using the window wiper.
Apply steam to the glass surface from a
distance of approximately 20 cm until
the surface is moistened evenly.
Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip of the window wiper. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Suited for all washable wall and floor cover-
ings, e.g. stone floors, tiles and PVC floors.
Work slowly on very dirty surfaces to allow
the steam to act on the dirt for a longer pe-
riod of time.
Note:Detergent residue or care emulsions
that are still present on the surfaces to be
cleaned, can lead to smears when steam
cleaned. However, these will disappear
with repeated cleaning procedures.
Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
– 9
EN
Window wiper

Floor nozzle

19