Cleaning And Maintenance; Cleaning The Mesh Filters In The Water Supply Hose - IKEA UDDARP AA-2306740-2 Bedienungsanleitung

ENGLISH

Cleaning and maintenance

For any cleaning and maintenance, switch off and unplug the
washing machine.
Do not use flammable fluids to clean the washing machine.
CLEANING THE OUTSIDE OF THE WASHING MACHINE
Use a soft damp cloth to clean the outer parts of the washing
machine.
Do not use glass or general purpose cleaners, scouring powder
or similar to clean the control panel – these substances might
damage the printing.
CHECKING THE WATER SUPPLY HOSE
Check the inlet hose regularly for brittleness and cracks. If
damaged, replace it by a new hose available through our
After-Sales Service or your specialist dealer.
For water stop hoses: check the small safety valve inspection
window (see arrow). If it is red, the water stop function was
triggered, and the hose must be replaced by a new one.

CLEANING THE MESH FILTERS IN THE WATER SUPPLY HOSE

1. Close water tap and unscrew the inlet hose.
2. Clean the mesh filter at the hose's end carefully with a fine
brush.
3. Now unscrew the inlet hose on the back of the washing
machine by hand. Pull out the mesh filter from the valve on
the back of the washing machine with pliers and carefully
clean it.
4. Insert the mesh filter again. Connect the inlet hose to
water tap and washing machine again. Do not use a tool to
connect the inlet hose. Open the water tap and check that all
connections are tight.
14