Electrical Warnings; Environmental Concerns; Cleaning And Maintenance - IKEA UDDARP AA-2315824-3 Bedienungsanleitung

ENGLISH
For models with hot fill: the hot water
inlet temperature must not exceed 60°C.
The washing machine is fitted with
transport bolts to prevent any possible
damage to the interior during transport.
Before using the machine, it is imperative
that the transport bolts are removed.
After their removal, cover the openings
with the 4 enclosed plastic caps.
After installation of the device, wait
a few hours before starting it so that it
acclimates to the environmental conditions
of the room.
Make sure that the ventilation openings
in the base of your washing machine
(if available on your model) are not
obstructed by a carpet or other material.
Use only new hoses to connect the
appliance to the water supply. The old
hose-sets should not be reused.
The supply water pressure must be in
the 0.1-1 MPa range.
Do not repair or replace any part of the
appliance unless specifically stated in the
user manual. Use only authorized After-
sales Service.
Self or non-professional repair may lead
to dangerous incident resulting in live
or health threatening and/or significant
property damage.
Spare parts will be available for a period of
either up to 7 or up to 10 years, according
to the specific regulation requirements.
The spare parts can be found:
https://parts-selfservice.whirlpool.com/en/
landing

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream of
the socket in accordance with the wiring

Environmental concerns

Disposal of packaging materials
The packaging material is 100% recyclable and is marked with
the recycle symbol.
The various parts of the packaging must therefore be disposed
of responsibility and in full compliance with local authority
regulations governing waste disposal.
Disposal of household appliances
This appliance is manufactured with recyclable or reusable
materials. Dispose of it in accordance with local waste disposal
regulations. For further information on the treatment, recovery
and recycling of household electrical appliances, contact your
local authority, the collection service for household waste or
Manufacturer
Ikea of Sweden AB - SE - 343 81 Älmhult, Sweden
rules and the appliance must be earthed in
conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to
the user after installation. Do not use the
appliance when you are wet or barefoot.
Do not operate this appliance if it has
a damaged power cable or plug, if it is
not working properly, or if it has been
damaged or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a
hazard - risk of electric shock.

CLEANING AND MAINTENANCE

WARNING: Ensure that the appliance
is switched off and disconnected from
the power supply before performing any
maintenance operation. To avoid risk
of personal injury use protective gloves
(risk of laceration) and safety shoes (risk
of contusion); be sure to handle by two
persons (reduce load); never use steam
cleaning equipment (risk of electric shock).
Non-professional repairs not authorized
by the manufacturer could result in a
risk to health and safety, for which the
manufacturer cannot be held liable. Any
defect or damage caused from non-
professional repairs or maintenance
will not be covered by the guarantee,
the terms of which are outlined in the
document delivered with the unit.
the store where you purchased the appliance. This appliance
is marked in compliance with European Directive 2012/19/EU,
Waste Electrical and Electronic Equipment (WEEE) and with the
Waste Electrical and Electronic Equipment regulations 2013 (as
amended). By ensuring this product is disposed of correctly, you
will help prevent negative consequences for the environment
and human health.
The symbol on the product or on the accompanying
documentation indicates that it should not be treated as
domestic waste but must be taken to an appropriate collection
center for the recycling of electrical and electronic equipment.
6