Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Daily use
PREPARING THE LAUNDRY
Empty pockets
•
Coins, paper clips, etc. could damage the load
and the washing machine components.
•
Tissues will break down during the wash cycle,
and the fragments will have to be subsequently
removed by hand.
Close all zippers, buttons, and hooks. Tie all ribbons or belts
•
Insert the smaller garments (e.g. nylon hosiery,
belts, etc.) and garments with hooks (e.g.
braziers) into a fabric bag or a pillowcase with
a zipper.
•
Remove any rings from curtains, or else place
the curtains inside a fabric bag together with
the rings.
HOW TO USE THE WASHING MACHINE
1. Load laundry
Open the door and load the laundry. Load the
articles one at a time loosely into the drum,
without overfilling. Observe the load sizes given
in the "PROGRAMME CHART" table.
Overloading the machine will result in
unsatisfactory washing results and creased
laundry.
2. Close door
3. Open water tap
Make sure that the washing machine is
connected to the water mains.
Open the water tap.
Switch on washing machine
Press the "ON/OFF"
, the "Start/Pause"
4. Set the desired programme
Select the required programme with the "Program selector" dial.
The washing machine automatically displays the default
temperature setting and then the duration of the washing cycle.
Adjust the temperature and/or spin speed settings if needed
with the relative buttons.
Change temperature, if needed
Press the "Temperature" button
the temperature setting until cold wash has been set ("- -" will
be shown on the display). Pressing the button again sets the
highest possible setting.
Change spin speed, if needed
Press the "Spin" button
speed until the spin cycle is turned off ("0" will be shown on the
display). Pressing the button again sets the highest possible
setting.
Select functions, if needed
Press the button to select the function; the respective symbol on
display illuminates.
Press the button again to cancel the option; the light
extinguishes.
If the selected function is incompatible with the programme
set, the incompatibility will be signalled by a buzzer (3 beeps)
and the corresponding indicator light will flash.
Make sure that no laundry gets
stuck between door glass and
rubber seal.
Close the door so that you can hear
it click shut.
lamp flashes slowly.
to progressively lower
to progressively decrease the spin
If the selected function is incompatible with another
previously set function, only the most recent selection will
remain active.
5. Add detergent
Pull out the detergent dispenser and add
detergent (and additives/softener) into the relative
compartments as described in section "DETERGENT
DISPENSER". Observe the dosing recommendations
on the detergent pack.
Correct dosing of detergent / additives is important,
because:
•
it optimizes the cleaning result
•
it avoids irritating residues of surplus detergent in your
laundry
•
it saves money by avoiding waste of surplus detergent
•
it protects the washing machine by avoiding calcification of
components
•
it respects the environment by avoiding unnecessary
environmental burden.
6. Delaying the start of a programme
•
To set a programme to start at a later time, see the section
"FUNCTIONS / START DELAY" at page 12.
7. Start programme
•
Press the "Start/Pause"
illuminates, the door locks and the "Door locked"
indicator lights up with a "beep".
•
To avoid overflow, do not open the detergent dispenser
during a running programme anymore.
The remaining programme duration can vary. Factors like
unbalance in the wash load, or foam formation, can have an
effect on the programme duration.
8. Change the settings of a running programme, if
needed
You can still change the settings while a programme is
running. The changes will be applied, provided the respective
programme phase has not finished yet.
To change the settings of a running programme:
•
Press "Start/Pause"
running programme on pause.
•
Change your settings.
•
Press "Start/Pause"
continue the programme.
If you have changed the programme, do not add detergent
for the new programme.
To prevent that a running programme is changed by accident
(for instance by children), use the "Key lock"
"FUNCTIONS").
Pause a running programme and open the door, if needed
•
Press "Start/Pause"
•
Provided water level or temperature is not too high, the
"Door locked"
indicator light turns off. You can open
the door, for example to add more laundry, or to remove
laundry which was loaded by mistake.
•
Press "Start/Pause"
9. Cancelling a running programme, if needed
•
Press and hold the "ON/OFF"
shown in the display until the washing machine stops.
•
If the water level and temperature are low enough, the door
unlocks and may be opened.
•
The door remains locked if there is water in the drum.
To unlock the door, switch the washing machine on, select
the "Spin & Drain" programme and turn the spin option off
by setting the spin speed to "0".
•
The water is emptied and the door unlocks at the end of the
programme.
. The relative indicator lamp
(confirmation "beep") to put the
(confirmation "beep") again to
(see section
to pause a running programme.
to proceed with the programme.
button: a count down is
10
Werbung
Inhaltsverzeichnis
