Functions - IKEA UDDARP AA-2306740-2 Bedienungsanleitung

ENGLISH

Functions

If the selected function is incompatible with the set
programme, the incompatibility will be signalled by a buzzer
(3 beeps).
If the selected function is incompatible with another
previously set function the function will not be enabled.
CLEAN+
Clean+ is an function working on 3 different levels (Intensive,
Daily and Fast) that are specially designed to set the right
washing action, depending on your cleaning needs:
Intensive : this function is designed for high levels of
dirtiness, removing most stubborn stains.
Daily : this function is designed to remove everyday stains.
Fast : this function is designed to remove lightly soiled
stains.
INTENSIVE RINSE
By selecting this function, the efficiency of the rinse is increased
and optimal detergent removal is guaranteed. It is particularly
useful for sensitive skin. Press the button once, two or three
times to select an additional 1
the standard cycle rinse and remove all traces of detergent.
Press the button again to go back to the "Normal rinse" rinse
type.
START DELAY
To set the selected programme to start at a later time (Max 24h),
press the button to set the desired delay time.
The symbol lights on the display when this fuction is
enabled. To cancel the delayed start, press the button again
untile the value ‚''0'' is shown on the display.
FRESH PLUS
This function enhances washing performance by generating
steam to inhibit the proliferation of the main bad odour sources
inside the machine. After steam phase, the washing machine
will perform gentle tumbling through slow rotations of the
drum. Fresh Plus function starts after the cycle ends for a
maximum duration of 6h and you can interrupt it at any time by
pressing any button on control panel or turning the knob.
Wait around 5 minutes before door can be opened.
TEMPERATURE
Every programme has a predefined temperature. If you want to
change the temperature, press the "temperature" button.
The value appears on the display.
SPIN
Every programme has a predefined spin speed.
If you want to change the spin speed, press the "Spin" button.
The value appears on the display.
, 2 or 3 rinses after
KEY LOCK
To lock the control panel, press and hold the "Key lock"
button for approximately 3 seconds. The symbol
up on the display to indicate that the control panel has been
locked (with the exception of the "ON/OFF"
This prevents unintentional changes to programmes, especially
with children near the machine.
To unlock the control panel, press and hold the "Key lock"
button for approximately 3 seconds.
BLEACHING
If you wish to bleach the laundry, load the washing machine and
set the "Rinse & Spin" programme.
Start the machine and wait for it to complete the first water
filling cycle (roughly 2 minutes). Put the machine in pause mode
by pressing the "Start/Pause"
drawer and pour the bleach (observe the recommended doses
indicated on the package) into the main wash compartment
where the partition was previously mounted. Restart the cycle
by pressing the "Start/Pause"
If desired, it is possible to add fabric softener into the
appropriate compartment of the detergent drawer.
DEMO MODE
This function is only used for sales presentations. By this you
can interact with washing machine and see it working without
water. To enter Demo mode, switch the washing machine ON
and OFF again. Press and hold "Start/Pause"
within 5 seconds press also "ON/OFF"
buttons for 10 seconds, the display shows "dOn".
To deactivate this function, switch the washing machine OFF.
Than press and hold "Start/Pause"
press also "ON/OFF" button and hold both buttons for 2
seconds, the display shows "dOf".
12
will light
button).
button, open the detergent
button.
button, then
button and hold both
button, within 5 seconds