Inhaltsverzeichnis
Werbung
Diagnostic / Diagnostic / Diagnose
A
A
LARM
Your machine is equipped with a set of controllers and sensors.
This means that operating alerts may appear on your terminal.
These alerts may be of diff erent levels:
Red, with a «STOP»; it is vital that you stop the machine immediately and investigate the cause of the malfunction according to the
alert. In this case, the seeding quality is directly called into question.
Orange, with «WARNING»; it is a good idea to quickly investigate the cause of the problem in order to improve your machine's
operation. However, the seeding quality is not in doubt.
In certain cases, these alerts may lead to damage to your equipment. Example: calculator overheating.
Alarm level of gravity
Alarm descriptive text
Alarm code
Description of the alarms
Alarm code
520456
520457
520518
The seed drill must have actuators on all the rows
520521
520532
520544 / 520656 /
520768
520545 / 520657 /
520769
520549 / 520661 /
520773
520554 / 520666 /
520778
520563 / 520675 /
520787
521088 -> 521151
521152 -> 521215
521216 -> 521279
521472 / 521473
Seed drill/Fertiliser distributor widths incompatible
The fertiliser distributor track does not correspond
521474 / 521475
Tramline parameters incompatible with the actua-
521481
521482 -> 522251
522257 -> 522384
522385 -> 522392
D
ESCRIPTION
Turbine speed too low during seeding
Turbine speed too high
The forward movement speed is to high,
risk of blockage
Low level alert when the doser is started up
Doser speed too high
Doser speed too low
The doser speed is not stable
The fl ow rate test hatch is open
The gearbox casing is open
Blockage sensor disconnected or at fault
Flap actuator disconnected
or electronic board at fault
Row No. X blocked
to the seed drill setting
tor position
System electronic malfunction
Too much dust on the blocking sensor No. X
Hatch opening cylinder failure
S
OLUTION
Increase the turbine speed
Reduce the turbine speed
Change the seeding confi guration or contact your
reseller to top up your seed drill's equipment.
Reduce its working speed
Fill the 1 hopper
Perform another fl ow rate test,
increasing the groove volume slightly
Perform another fl ow rate test,
reducing the groove volume slightly
Contact your dealer.
Close the hatch
Close the casing
Contact your dealer.
Stop seeding and check the fl ow
on the row concerned
Change the seeding confi guration or contact your
reseller to top up your seed drill's equipment.
Contact your dealer.
Clean the blocking sensor No. X
Contact your dealer.
9
EN
167
Werbung
Inhaltsverzeichnis
