Teka IBF 64 Infinity G1 Montageanleitung Und Empfehlungen Zur Verendung Und Wartung Seite 28

EN
manufacturer in the
instructions for use
as adequate or
stovetop protectors
incorporated into
the device. The use
o f i n a d e q u a t e
p r o t e c t o r s c a n
cause accidents.
It is necessary
t o a l l o w
a p p l i a n c e
disconnection after
i n s t a l l a t i o
n . Disconnection
devices must be
incorporated to
the fixed electrical
i n s t a l l a t i o n ,
according to the
installation regu-
lations.
Installation
Installation with cutlery drawer
Fig.2a (5 WIRES)
28
If you wish to install furniture or a
cutlery drawer under the hob, a sepa-
ration board must be fitted between
the two. Accidental contact with the
hot surface of the device's housing is
thus prevented.
The board must be fitted 18 mm bene-
ath the under part of the stovetop.
Electrical connection
Before you connect the stovetop to
t h e
the mains, check that the voltage
and frequency match those specified
on the stovetop nameplate, which is
underneath it, and on the Guarantee
Sheet, or if applicable on the technical
data sheet, which you must keep
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
top housing or the oven housing, if it
is installed in the same unit.
Warning:
The electrical connection
must be properly grounded,
following current legislation,
otherwise the induction hob may
malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
high temperature that this type of
device attains.
Only the TEKA official techni-
cal service can handle or repair the
appliance, including replacement
of the power cable.
Before disconnecting the hob
form the mains, we recommend
switching off the cutoff switch and
waiting for approximately 23
seconds before disconnecting from
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical
data sheet together with the
instructions manual throughout
the product's service life. These
contain important technical
information.
About induction
Advantages
With an induction hob, the heat is
transmitted directly to the pan.
This has a number of advantages:
-Saves time.
-Saves energy.
-Easy to clean as if the food comes
into contact with the glass plate, it
does not burn easily.
-Improved energy control. The energy
is transferred to the pan as soon
as the power controls are pressed.
In addition, as soon as the pan is
removed from the cooking zone,
the power supply stops. It is not
necessary to switch the power off first.