Product Description; General Product Overview - Novoferm NovoDock L530 Original-Montage- Und Betriebsanleitung

3

Product description

1
Fig. 1: Exemplary representation, illustration may deviate from the product
1 Control unit
2 Underride area
3 Cabling
4 Lip leveller
The loading bridge platform is hinged on the side of
the loading ramp and can therefore be adjusted in
height on the side of the vehicle. The lip leveller is
used for placing the platform on the truck loading
area. The hinged lip controls the height compensation
even if the truck is moving in height. At the same
time, it allows the truck to be driven over with a forklift
truck.
The loading bridge platform is aligned flush with the
ground and can be driven over with full nominal load
when it is in resting position.
Option: Retracting flaps on the sides on the
lip leveller
The lip leveller of the loading bridge may be equipped
with retracting flaps on the side that are moved back-
wards independently of the central part (i.e. automat-
ically in the case of resistance or manually sliding).
This reduces the width of the contact surface so that
trucks with narrow loading areas can also be
handled. When the loading bridge moves back to its
resting position, the retracting flaps at the sides are
automatically moved back to the initial position. This
means that the full width of the lip leveller is available
again the next time it is extended.
These assembly, operation and maintenance instructions must be kept for the entire period of use!
5
4
2
3
5 Lip leveller cylinder
6 Hydraulic unit
7 Loading bridge platform
8 Rating plate
3.1

General product overview

6
7
10
9
8
9
10
11
12
Fig. 2: Exemplary representation, illustration may deviate from the
product
12
11
Side panel/protective panel
Lifting cylinder
Warning stripes
Frame
EN - 27