Open Locks With Parallel Code; Open Locks With Otc Dependent (Xx0) - Insys Elostar Master Kurzbedienungsanleitung

EloStar Master / EloStar Master smart

2.6.8 Open Locks with Parallel Code

The first user opens lock 1, the second one opens lock 2 and a third one,
if necessary, opens lock 3. All users open according to their authorisation.
1. Open lock 1 according to your authorisation.
See the instructions on opening at the beginning of this chapter. Lock
1 opens.
Open | Lock open: 1 is on display.
2. Another user carries out step 1 at lock 2 and, if necessary, a third
one does the same at lock 3.
Open | Please wait is on display. The lock bolt retracts.
Open | Lock open: No. is on display.
You have successfully opened the locks in your system.

2.6.9 Open Locks with OTC Dependent (XX0)

With EloStar Master (smart), product version XX0 with FlatControl, firmware
version < 22 only.
OTC (one time code) is also called single-use code. The use of dependent
OTC requires that several preconditions are fulfilled (see manual).
With the conditions for OTC dependable fulfilled, users can open locks or
grant persons access to locks
● with personnel - / user number, with RFID card and with OTC or
● with personnel - / user number, PIN code or card and OTC.
Press key Clear and release it after immediately, and, if required,
1.
press key < or key > and key Enter in order to select Open.
With key < or key >, and key Enter select the lock, if required.
2.
Code entry | Standard is on display, as it may be.
With < or >, and key Enter select Standard, if required.
3.
Standard | Code entry | Master or
Standard | Code entry | Staffnb: is on display.
Enter your user- / personnel number and confirm with Enter, if required.
4.
User / Staffnb: and Code: is on display.
5. Enter PIN code, for example.
CIT function | Code: is on display.
6. Enter your OTC dependent.
For users who open with OTC only, Open| Please wait is on display. The
lock bolt is retracted. Open | Lock open: no. is on display. Finally,
System unlocked is displayed.
In case the code has been generated via „Create single-use code master", you
cannot open, but grant a person access to the lock.
You have successfully opened the lock.
Kurzbedienungsanleitung V.1.01D 36 Quick Reference Guide V.1.01D
Operation