cecotec bolero SQUAD I 3000 Bedienungsanleitung Seite 62

ENGLISH
Induction coil
4
Induced currents
5
Touch controls
The buttons react to touch, so there is no need to apply any pressure.
-
Use the base of your finger, not the tip. Fig. 11
-
You will hear a beep every time the hob detects a finger.
-
Make sure the buttons are always clean, dry and there are no objects (for example, a
-
utensil or a cloth) covering them. Even a thin film of water can make it difficult to operate
the buttons.
Selection of the suitable cookware
Use only cookware with a suitable base for induction hobs.
-
Look for the induction symbol on the packaging or on the bottom of the cookware.
-
You can check if your cookware is suitable with a magnet test. Move a magnet towards
-
the cookware base (Fig. 12). If the cookware attracts it, this means that it is suitable for the
induction hob. If you do not have a magnet:
Pour some water in the cookware you wish to check and place it over one of the cooking
1
areas.
If does not appear on the display flashing and water heats up, the cookware is suitable.
2
Cookware manufactured with the following materials are not suitable: pure stainless steel,
aluminium or copper without magnetic base, glass, wood, china, ceramics and earthenware.
Do not use kitchen utensils with serrated edges or with a curved base. Fig. 13
-
Make sure the base of the cookware is smooth, flat against the glass and has the same
-
size than the cooking area. Use cookware whose diameter is the same as the cooking area
selected. The use of a slightly wider cookware will increase the efficiency of the energy
used. If you use a smaller cookware, efficiency will be affected. The hob may not detect a
cookware smaller than 140 mm. Always centre the cookware in the cooking area. Fig. 14
Always lift the cookware off the induction hob, do not slide it, as it could scratch the glass.
-
Fig. 15
Start cooking
Fig. 16
Hold down the On/off button for 3 seconds. After turning on the hob, it will beep and all the
1
indicators will show - or - -, indicating the induction hob is on standby mode.
Place suitable cookware in the cooking area you wish to use. Make sure the bottom of the
2
cookware and the cooking area surface are clean and dry.
When pressing the cooking area selection button, the indicator next to the button will flash.
3
62