Working Instructions; Cleaning And Servicing; Cleaning; Maintenance - Parkside PSSSA 20-Li B2 Originalbetriebsanleitung

4. After finishing your work, first remove
the saw blade (11.1/11.2) from the
saw cut and then switch the device off.

Working instructions

Wear protective gloves when hand-
ling the saw blade. In this way, you
avoid injury from cuts.
• Clamp the workpiece. Use a clamping
device for small workpieces.
• Draw a line to specify the direction in
which the saw blade is guided.
• Hold the device securely by the handle.
• Set the pendulum stroke on or off.
• Turn on the device.
• Wait until the device has reached full
speed.
• Place the bottom plate (6)/footplate
(12) on the workpiece.
• Do not apply too much pressure. Move
the device slowly. Let the device do the
work.
Excessive pressure may bend and
break the saw blade.
• Before shutting down the device, switch
it off and wait for it to come to a com-
plete standstill.
Cleaning and Servicing
Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
Always wear protective gloves
when handling the saw blade in
order to avoid cutting yourself.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.

Cleaning

The device must not be
sprayed with water or placed
in water. Otherwise there is
a risk of electric shock.
Do not use any cleaning agents or
solvents. This could damage the
device irreparably. Chemical subs-
tances may attack the plastic parts
of the device.
• Keep the ventilation slits, motor housing
and handles of the machine clean.
Use a damp cloth or brush to do this.

Maintenance

The device is maintenance free.

Transport

Before each transport, remove the battery
and the accessory tool from the device.
Always carry the device by the handle.
GB IE
31