Maintenance And Cleaning; Cleaning The Suction Filter; Troubleshooting; 10 Guarantee - DAB DIVERTEK 500 Installations- Und Wartungsanleitungen

If the pump has been used with substances that tend to form a deposit, or with water containing chlorine, rinse it after use with a powerful jet of
water in order to avoid the formation of deposits or encrustations which would reduce the characteristics of the pump.
8

MAINTENANCE AND CLEANING

In normal operation the pump does not require any type of maintenance. In any case, all repair and maintenance work must be carried out only
after having disconnected the pump from the supply mains. When restarting the pump, ensure that the suction filter is always fitted so as not to
create the risk or possibility of accidental contact with moving parts.
8.1

Cleaning the suction filter

• Switch off the electric power supply to the pump.
• Drain the pump.
• Clean with a jet of water and a brush. (Fig.8)
9

TROUBLESHOOTING

Before taking any troubleshooting action, disconnect the pump from the power supply (i.e. remove the plug from the socket). If
there is any damage to the power cable or pump, any necessary repairs or replacements must be performed by the manufacturer
or his authorized customer support service, or by an equally-qualified party, in order to prevent all risks
INCONVENIENTI
The pumps does not start.
The pump delivers no water
The flow rate is too low.
The pump does not stop.
The pump stops running (possible
intervention of the thermal overload
switch)

10 GUARANTEE

Any modification made without prior authorisation relieves the manufacturer of all responsibility. All the spare parts used in repairs
must be authentic and all accessories must be authorised by the manufacturer, in order to ensure maximum safety of the
machines and of the systems in which they may be installed
This product is covered by a legal guarantee (in the European Community for 24 months from date of purchase) against all defects that can be
assigned to manufacturing faults or to the material used. The product under guarantee may, at discretion, either be replaced with one in perfect
working order or replaced free of charge if the following conditions are observed:
the product has been used correctly in compliance with the instructions and not attempt has been made to repair it by the buyer or by
•
third parties.
the product has been consigned to the outlet where it was purchased, attaching a document as proof of purchase (invoice or cash
•
register receipt) and a brief description of the problem found.
The impeller and parts subject to wear are not covered by the guarantee. Intervention under guarantee does not extend the initial guarantee
period in any way.
PROBABILI CAUSE
1. The motor is not powered
2. There is no water (pumps in alarm mode)
3. The non-return valve is blocked
4. The pump is not enabled by the float.
1. The suction grid or piping are clogged
2. The impeller is worn or stuck
3. The head required is higher than the pump's
characteristics
1. The suction grid is partially blocked
2. The impeller or delivery pipe are partially blocked or
encrusted
1. The pump is not disabled by the float.
1. The liquid to be pumped is too dense and overheats
the motor.
2. The water temperature is too high
3. A solid object is blocking the impeller
4. Power supply doesn't comply with the nameplate's the
data
ENGLISH
1. Check the power supply
2. Check the water level
3. Remove obstruction on the non-return valve
4. Make sure the float can move freely.
1. Remove the obstruction.
2. Replace the impeller or remove the obstruction.
1-2 Remove any obstruction
1. Make sure the float can move freely.
1-2-3-4 Disconnect the power cord, correct the reason for
overheating; then wait until the pump is cooled plug the
cord and resume operation
11
RIMEDI