Warnings; Skilled Personnel; Safety; Responsibility - DAB DCONNECT BOX2 Anleitungen Für Die Installation

3. WARNINGS

- Read this documentation carefully before installation and always refer to the manuals of each product to be connected via the
DConnect Box2.
- Installation and operation must comply with the local safety regulations in force in the country in which the product is installed.
Everything must be done in a workmanlike manner.
- Failure to respect the safety regulations not only causes risk to personal safety and damage to the equipment, but invalidates
every right to assistance under guarantee.

3.1 Skilled personnel

- It is advisable that installation be carried out by competent, skilled personnel in possession of the technical qualifications required
by the specific legislation in force.
- The term skilled personnel means persons whose training, experience and instruction, as well as their knowledge of the
respective standards and requirements for accident prevention and working conditions, have been approved by the person in
charge of plant safety, authorizing them to perform all the necessary activities, during which they are able to recognize and avoid
all dangers. (IEC 60730).

3.2 Safety

- Use is allowed only if the electric system is in possession of safety precautions in accordance with the regulations in force in the
country where the product is installed. Check that the DConnect Box2 has not been damaged.
- It is indispensable to check that all the leads and accessory cables are correctly inserted in the relevant extractable terminals or
dedicated doors.
Failure to observe the warnings may create situations of risk for persons or property and will void the product guarantee.

3.3 Responsibility

The Manufacturer does not vouch for correct operation of the electropumps or accessories, or answer for any damage that they may cause if
they have been tampered with, modified and/or run outside the recommended work range or in contrast with other indications given in this
manual. The Manufacturer declines all responsibility for possible errors in this instructions manual, if due to misprints or errors in copying. The
Manufacturer reserves the right to make any modifications to products that it may consider necessary or useful, without affecting their essential
characteristics.

4. INTRODUCTION

The DConnect Box2 is the interface device for remote control via APP of compatible DAB products.
The DConnect Box2 is mainly designed for Residential Building Service (RBS) systems, consisting of up to 4 pumps.

5. SYSTEM REQUIREMENTS

5.1 APP requirements: Smartphone

- Android ≥ 6 (API level 23).
- IOS ≥ 12
- Internet access

5.2 PC requirements

- WEB browser that supports JavaScript (e.g. Microsoft Edge, Firefox, Google Chrome, Safari).
- Internet access.
Microsoft© has announced that Internet Explorer 10 will only be supported until January 2020. For this reason the webAPP does not
support Internet Explorer.

5.3 Network requirements

- Active and permanent direct Internet connection on site.
- Modem/Router WiFi.
- Good quality WiFi signal and power in the area where the DConnect Box2 is installed.
NOTE 1: If the WiFi signal is deteriorated, we suggest using a Wifi Extender.
NOTE 2: The use of DHCP is recommended, although a Static IP can be set.

5.4 Firmware Updates

Before starting to use the DConnect Box2, make sure that the product is updated to the latest SW version available.
Updates ensure you of a better use of the services offered by the product.
To get the most out of the product, also check out the online manual and watch the demonstration videos. All the necessary information is
available at dabpumps.com or on: Internetofpumps.com

5.5 DAB Product requirements

The DAB products to be controlled by the DConnect service (where possible) must be updated to the latest firmware version available.

6. CONTENT OF THE PACK

- DCONNECT BOX2.
- Power supply cable.
- Electric connectors for Modbus connections, I/O.
- Quick Guide.
NOTE: the DConnect Box2 is sold separately or included with the purchase of the E.sybox Diver as part of the product. It replaces the COM Box
supplied with the DTron3.
ENGLISH
13