Safety; General Safety Information; Electrical Safety; Operational Safety - Heidolph Hei-MIX Unimax 2010 Betriebsanleitung

Safety

Safety

General safety information

➜
Before commissioning and using the device, familiarize yourself with all the safety
regulations and guidelines for occupational safety applicable at the place of use and
observe them at all times.
➜
Only operate the device if it is in perfect technical condition. In particular, make
sure that the device is free of visible damage.
➜ If there is missing or misleading information on the device or on occupational
safety, contact the responsible safety specialist or our technical service.
➜
Only use the device in accordance with the regulations for intended use ("Intended
use" on page 31).

Electrical safety

➜ Ensure that the voltage indicated on the rating plate matches the supply voltage of
the country in which the device is being used.
➜
Ensure that the mains socket-outlet is protected by means of a residual-current
device (RCD).
➜ Always use the supplied power supply 3-pin cord provided with the device (phase,
neutral, ground).
➜
Only replace the device fuses with original fuses from the manufacturer (available
as accessories, see section "Accessories" on page 47).
➜
Before each operation, make sure that the power supply cord is free of visible
damage.
➜ Have repairs and/or maintenance work on the device carried out exclusively by an
authorized and skilled electrician or by the technical service department of Heidolph
Instruments.
➜ Always switch the device OFF and disconnect it from the power supply before
carrying out maintenance work, cleaning, or repairs.

Operational safety

➜ Operate the device under a closed ventilated fume hood when working with poten-
tially hazardous substances (according to EN 14175 and DIN 12924).
➜
Do not make any unauthorized changes or modifications to the device!
➜ Only use genuine spare parts and accessories, or those expressly approved by the
manufacturer!
➜
Rectify malfunctions or faults on the device immediately.
➜ Shut down the device and disconnect it from the power supply if it is not possible to
eliminate the malfunction or rectify the fault immediately.
➜
Observe all other applicable regulations such as laboratory and workplace guide-
lines, recognized safety technology rules and special local regulations.
33