hanseatic 65C40C1-E11B04A Gebrauchsanleitung Seite 65

3. Close the appliance door such that there
is an open gap of approx. 10 cm.
4. Lightly lift and guide the appliance door
forward out of its hinges.
Installing the appliance door
1. Gripping it with both hands, hold the ap-
pliance door (12) at an angle.
2. Align the bottom of the appliance door
straight with the appliance and hook the
hinges into the openings of the side walls.
3. Open the appliance door fully.
4. Fold the clips (24) on both sides all the
way back again.
5. Close the appliance door carefully. The
appliance door must sit flush when
closed. If the appliance door does not sit
flush when closed or if there is a cracking
sound when closing it, the door has not
been installed properly.
Correct the position of the hinges and
clips, if necessary, until the appliance
door opens and closes smoothly again.
Cleaning the glass panes
The appliance door (12) contains two glass
panes that should be cleaned on both sides
regularly.
1. Remove the appliance door (see chapter
"removing the appliance door").
2. Place the appliance door with the front
side on a soft base.
Cleaning the oven
3. Take both panes with one finger on each
side in the gap, and on both sides push
the rear clamp (25) forward so that the in-
ner pane (26) is released from the clamp
brackets (27).
4. Remove the inner pane from the appli-
ance door.
5. Clean both panes with warm clean water.
6. Dry the panes thoroughly.
7. Return the inner pane to the appliance
door and push it firmly, with the clamps,
into the clamp brackets.
8. Reinstalling the appliance door (see
chapter "Installing the appliance door").
Page EN-23
(26)
(25)
(27)