Cutting Means Removal And Installation - Honda HRX537C4HYEA Betriebsanleitung

5. Loosen the top [3] and
bottom [4] drive clutch cable
locknuts with a 10 mm
wrench. Move the adjuster
[5] up or down, as required,
until the mower operates as
outlined in step 4. Tighten
the locknuts.
Throttle Cable Adjustment
1. Move the throttle lever [1] to the
fast position [2].
2. Remove air cleaner cover.
3. Check that the control
lever [3] just touches the
stopper screw [4]. If
adjustment is required,
proceed to step 5.
4. Loosen lock nuts [5] with
a 10 mm wrench. Move
adjuster [6] up or down as
required to achieve the
setting in step 3. Retighten
locknuts [5].

CUTTING MEANS REMOVAL AND INSTALLATION

If you remove the cutting means for sharpening or replacement, you
will need a torque wrench for installation. Wear heavy gloves to
protect your hands.
CUTTING MEANS SHARPENING: To avoid weakening the cutting
means, or causing imbalance or poor cutting, the cutting means
should be sharpened by trained staff at an authorized Honda dealer.
CUTTING MEANS REPLACEMENT: Use Honda Genuine
replacement cutting means or their equivalent.
16
[1]
[4]
[3]
[6]
Cutting Means Removal
1. HYEA: Put the throttle lever in the STOP position.
HZEA: Turn the key to the OFF position.
2. Disconnect the spark plug cap. Tilt the mower to the right so the
fuel cap is up. This will help prevent fuel leakage, motor oil seeping
into the air filter, and hard starting.
[4]
[3]
[3]
[4]
[5]
[2]
[1]
3. Use a 14 mm (6 point) socket wrench and remove the two
cutting-means bolts [1] and special washers [2] from the
cutting-means control assembly [5]. Use a wooden block to
prevent the cutting means from turning when removing the bolts.
4. Remove the upper [4] and lower cutting means [3].
Cutting Means Installation
1. Clean dirt and grass from around the cutting means mounting
area.
2. Install the cutting means [3] and [4] using the two cutting-means
bolts [1] and special washers [2] as shown.
[7]
[5] [6]
Operating this mower with only one cutting means will
result in an improperly seated cutting means that can be
thrown from the mower and seriously hurt or kill someone.
Always use both cutting means as a set.
Be sure to install the special washers with the concave side toward
the cutting means and the convex side toward the head of the bolt.
The cutting-means bolts are specially designed for this application
and must not be replaced with other bolts.
ENGLISH
[3] [4]

WARNING
[5]
[2]
[1]