HBM PACEline CMA-Serie Bedienungsanleitung Seite 18

18
Example:
Charge amplifier and 20 kN force transducer.
Content written by HBM, on the basis of the individual test certificate: Area 3
of the CMA20kN charge amplifier with identification no. 123456, made by
HBM on 27.6.2007.
Template: High Level Voltage
Parameter
Transducer electrical
signal type
Minimum force/weight
Maximum force/weight
Minimum electrical
value
Maximum electrical
value
Mapping method
AC or DC coupling
Output impedance of
the sensor
Response time
Excitation level
(nominal)
Excitation level
(minimum)
Excitation voltage type
Max. current draw at
nominal excitation level
1)
Typical values for the CFT/20kN force transducer
HBM
1)
Value Unit
Sensor
voltage
0.000 N
20.000k N
0.00000 V/V
+9.5700 V/V
Linear
DC
10.0 Ohm
1.0000000u sec
24.0 V
18.0 V
DC
50.12m A
Change
requires
rights to
level:
ID
CAL
The physical measurand and unit
are defined when the template is
created, after which they cannot
CAL
CAL
The difference between these
values is the sensitivity according
to the HBM test certificate or from
CAL
This entry cannot be changed.
ID
ID Output resistance according to the
HBM data sheet.
ID Of no significance for HBM
ID Supply voltage according to the
HBM data sheet.
ID Lower limit for the operating range
of the supply voltage according to
the HBM data sheet.
ID Type of supply voltage
ID
Maximum supply current
CMA
Explanation
be changed.
1)
calibration .
transducers.
A2559−1.0 en/de/fr