Switching On - Stihl HSA 66 Gebrauchsanleitung

English

Switching On

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
If necessary, remove the cover from
N
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the Battery
1
Insert the battery (1) in the power
N
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching on the Machine
Make sure you have a secure and
N
firm footing.
Stand upright – hold the power tool
N
in a relaxed position.
42
Make sure the cutting attachment is
N
not touching the ground or any other
objects.
Hold the power tool with both hands
N
– one hand on the control handle –
one hand on the loop handle.
2
Unlock the power tool by moving the
N
retaining latch (2) to ‚.
3
4
Push the switch lever (3) against
N
the loop handle and hold it there.
Push down the trigger switch
N
lockout (4) and depress the trigger
switch (5) and hold them in that
position.
The motor runs only if the retaining
latch (2) is on ‚ and the switch
lever (3) and trigger switch (5) are
operated simultaneously.
Trigger
Motor speed can be controlled with the
trigger switch. Depress the trigger switch
to accelerate the motor.
HSA 66, HSA 86