Connecting Charger To Power Supply; Charging The Battery - Stihl HSA 66 Gebrauchsanleitung

English
Horizontal cut
Hold the cutting blade at an angle of 0°
to 10° as you swing the hedge trimmer
horizontally, using both sides of the
blade.
Swing the cutting blade in an arc
towards the outside of the hedge so that
the cuttings are swept to the ground.
Repeat the procedure several times on
wide hedges.
38
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
2
Connect the charger to the power
1 N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger indoors only in dry
locations at an ambient temperature
between +5°C and +40°C.
Push the battery(1) into the
N
charger(2) until noticeable
resistance is felt – then push it as far
as stop.
2
HSA 66, HSA 86