Recommended Tools - Delta DC Wallbox-Ladegerat Installations- Und Bedienungshandbuch

Recommended Tools

The following tools are recommended for the DC Wallbox charger installation:
(1x) Voltmeter or digital multi-meter

(1x) Water level

(1x) Hammer

(1x) Concrete drilling machine

(1x) Wire cutters/strippers

®
(1x) Torx Tamper-Resistant T15 and T25 screwdriver

(1x) No.8 Flathead screwdriver and socket wrench

(1x) No.6 Flathead screwdriver

(1x) No.2 Philips screw driver

(1x) No.3 Philips screw driver

(1x) M50 conduit hub, conduit and wrench for main power wires

(1x) M25 conduit hub, conduit and wrench for Ethernet

(4x) Ring terminal RNB14-6 for L1/L2/L3/N wire (14mm

three-phase input
(3x) Ring terminal RNB38-6 for L1/L2/L3 wire (38mm

three-phase input
(1x) Ring terminal RNB14-6 for PE/ground wire (14mm

Important Safety Instructions.
Save these Instructions.
The DC Wallbox charger should be installed only by a licensed contractor, and/or a licensed

electrician in accordance with all applicable state, local and national electrical codes and stan-
dards.
Before installing the DC Wallbox charger, review this manual carefully and consult with a

licensed contractor, licensed electrician and trained installation expert to ensure compliance
with local building practices, climate conditions, safety standards and state and local codes.
WARNING!
!
Danger of electrical shock or injury. Turn off power at the panel board or load center before
working inside the equipment or removing any component. Do not remove circuit protective
devices or any other component until the power is turned off.
CAUTION!
!
T
O AVOID DAMAGE TO THE CHARGER OR PERSONAL INJURY
LOCATION IS ABLE TO SUPPORT THE WEIGHT OF THE
Installation and Operation Manual
2
copper wire) in models with 380V-415V
2
copper wire) in models with 200V-230V
2
copper wire)
,
MAKE SURE THE INSTALLATION
DC W
ALLBOX CHARGER
7
Before Installation
.