Regular Maintenance; Electrical System - Sunrise Medical Empulse StreetJet Bedienungsanleitung

8.2 Regular maintenance

Your pulling device is subject to high levels of stress
when being used, and requires regular checks in order to
guarantee your safety.
DANGER!
Carry out the visual inspections/maintenance as
described below regularly, at least every 4 weeks, and
ideally before you set off each time:
• Make sure that all screws and fasteners are secure.
• Functional and safety check of all lights (if fitted).
• Functional/safety check of the docking system (pulling
device and wheelchair) to make sure they are secure
and check for wear.
• Check the brake pads for wear and that the brakes
work properly. The disk brake must be re-adjusted/
maintained regularly by a dealer.
• Check function of the disk brake (get your dealer to
replace cables and brake pads if needed).
• Visual inspection of the fork and intermediate sub-
frame for damage (e.g. cracks, corrosion, deformation
etc.).
• Visual inspection of the wheelchair frame and back
tubes for damage (e.g. cracks, deformation, etc.)".
• Check tyres (tread, cracks, damages) and replace if
needed.
• Check the spoke tension and the rim and hub of all
wheels (wheelchair wheels as well) for damage.
• Check all cable and electrical connectors.
• Check that the steering head and handlebar are
secure.

8.3 Electrical system

If fault codes arise, or the electrical system of the pulling
device does not function as intended:
• Contact your dealer.
• Switch the pulling device on and push it forwards 1 m
by hand – check that it is working again
• Switch the battery off and carefully remove it from the
pulling device.
• Check all freely-accessible plug connections for dirt or
moisture. Clean the contacts if necessary with a clean,
dry cloth. Use contact spray if necessary, but do not
use lubricating or penetrating oil to clean the contacts
under any circumstances.
Empulse StreetJet Rev.A
53