Sunrise Medical Empulse StreetJet Bedienungsanleitung Seite 42

DANGER!
Re-tighten screws 30 minutes before using the StreetJet,
then retighten again after 24 hours.
DANGER!
In any case, make sure that the gap between the feet of
the user and the drive wheel is big enough, even at full
steering lock.
Under no circumstances must the drive wheel touch the
user's feet during driving, this may cause injury.
NOTE:
Wherever torque settings are specified, it is strongly
recommended that a torque meter (not included), is used
to verify correct torque specification is achieved. If no
other information is given, the generic torque for M6
screws is 7 Nm.
CAUTION:
Some of the screws that are used in manufacture have a
thread lock (blue dot on the threads) and can be used up
to three times, then they must be replaced by new screws
with thread lock. Alternatively, you can put Loctite™ 243
threadlock on the screws and re-fit them.
CAUTION!
Always observe the correct torque.
42
Adjusting the handlebar position
The position of the handlebar can be adjusted from 0
90 angle.
o
To change the angle of the stem, loosen the screw (A).
You can now move the stem to the angle you require
(infinitely adjustable). Once the adjustment is complete,
tighten the screw (A) to 20Nm.
DANGER!
Make sure to route and secure all cables properly. Make
sure not to bend or stretch cables. If necessary, use zip-
ties to fasten cables.
to
o
Empulse StreetJet Rev.A