Keimling Personal Blender Bedienungsanleitung Seite 37

Personal Blender™ - the speedy blender
Important safety notes
pliance once it has fallen in water. In
such a case, immediately disconnect
the mains plug.
– Before cleaning disconnect the mains
plug from the electricity supply and al-
low the product to cool off complete-
ly.
– When the product is not in use, when
it is being cleaned, assembled or taken
apart or in the case of any fault always
disconnect the plug immediately from
the mains electricity supply.
– Check the device and cable for damag-
es on a regular basis.
– Never use the mains cable as a carry-
ing strap.
– If the product has outlived its purpose
it must be put beyond use. Pull the
mains cable out of the socket and cut
the mains cable in half.
DANGER Danger to children and
other persons!
Children often fail to recog-
nise danger or tend to un-
derestimate it.
– This product is not intended for use by
persons (including children) with lim-
ited physical, sensory or intellectual
capacity or by persons lacking expe-
rience and/or knowledge unless they
are supervised by a person responsible
for their safety or have received from
such a person instruction on how to
use the product.
– Children should be supervised in order
to ensure that they do not play with
the device.
DANGER Risk of injury!
This product
blades. Improper handling of
the product may lead to in-
jury!
– Only use the product if the container is
securely screwed onto the blending or
grinding attachment!
– The blades are sharp! Take care when
screwing the container onto the blend-
ing or grinding attachment and when
cleaning the blades!
– Only open the lid of the attached con-
tainer once the blades have come to a
complete stop.
– Never touch moving parts!
– Do not place the product near easily
fl ammable materials such as curtains
or the like.
– Never allow the product to operate un-
supervised!
ATTENTION Danger caused by im-
proper use!
Improper use of the device
may lead to damage.
– The product may only be used by per-
sons familiar with its dangers and fea-
tures.
– Run the product for a maximum of 30
seconds at a time. Then let it rest for at
least 1 minute. If the product switches
itself off due to the overheating stop
function, leave it to cool down for at
least 20 minutes before using again.
has sharp
37