Post-Mounting Check - Endress+Hauser iTEMP TMT125 Bedienungsanleitung

Installation instructions
Now snap the device onto the DIN rail by firstly hanging the device on the DIN rail and then
pressing it down gently until it engages (→ å 4, item 1 and 2).
TMT125
Order Code:
Ser.No.:
TAG No.:
Fig. 4: DIN rail transmitter mounting
A: 35 mm DIN rail according to IEC 60715
3.5

Post-mounting check

After mounting the device, always run the following final checks:
Device condition and specifications
Has the device been mounted in accordance with specifications?
Is the device free of damage?
Is IP protection ensured?
Are the mounting screws (field housing) tightened securely?
28
DEVICE ID 452B4810CD-...
Made in Germany 2006
PTB 05 ATEX xxxx
87484 Nesselwang
II2 (1G/D)G EEx ia IIC T4
TMT125-XXXXXXXX
II(1) GD [EEx ia ] IIC
0123456789101
#
inst. per XA056R/09/a3/XX.XX
1019876543210
FISCO according to IEC TS 60079-27
-40°C< Ta < 70°C
+ H L -
PTB 05 ATEX xxxxX
II 3G EEx nA II T4
II 3G EEx nL IIC T4
II (3)G [EEx nL] IIC T4
Avoid electrostatic charge!
1
A
2
Notes
→ ä 26
Visual check
-
-
Endress+Hauser
TMT125
a0006837