Troubleshooting Guide - Kärcher IVM 100/36-3 Originalbetriebsanleitung

qualified electrician. Please contact a
KÄRCHER branch office if you have any
questions.
Replacing the main filter
1. Switch off the device.
2. Pull out the mains plug.
3. Unlock and remove the suction head.
4. Unlock and remove the spacer.
5. Remove the contaminated star pleated
filter.
6. Immediately after removing the contam-
inated star pleated filter from the unit,
place it in a bag and seal the bag tightly.
7. Dispose of the contaminated star pleat-
ed filter according to legal requirements.
8. Remove any dirt deposits from the clean
air side.
9. Check the sealing ring for damage.
10.Insert the new star pleated filter:
a Pull the new star pleated filter over the
filter vibrator on the spacer such that
the vibrating elements are aligned
centrally in the filter bags.
b Place the spacer with star pleated fil-
ter and filter vibrator on the filter ring.
c Lock the spacer.
11.Fit and lock the suction head.
Replacing the H filter
1. Secure the device with the parking
brakes.
2. Switch off the device at the power
switches.
3. Pull out the mains plug.
Illustration F
4. Unlock and remove the suction head.
5. Unscrew the hexagon screw anticlock-
wise using a suitable tool.
6. Remove the seals and the filter from the
suction head.
7. Remove any dirt deposits from the clean
air side.
8. Fit the new H filter in the reverse order.
Make sure that the seals are correctly
seated.
9. Apply a suitable agent (e.g. Loctite 243)
to the thread of the hexagon screw to
prevent unintentional loosening.
20
10.Tighten the hexagon screw clockwise.
11.Fit and lock the suction head.
Replace dust bag
1. Secure the device with the parking
brakes.
Illustration B
2. Pull the bow handle up.
The dirt receptacle is unlocked and low-
ered.
Illustration C
3. Pull the dirt receptacle out of the device
by the bow handle.
Illustration E
4. Turn up the dust bag.
5. Seal the dust bag tightly with the cable
tie.
6. Remove the dust bag.
7. Dispose of the dust bag in accordance
with statutory regulations.
Illustration D
8. Insert the new dust bag in the dirt recep-
tacle and carefully place it against the
container wall and the container floor.
9. Fold the edge of the dust bag over the
edge of the dirt receptacle to the outside.
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
10.Fit the dirt receptacle and lock it with the
bow handle.

Troubleshooting guide

DANGER
Unintentional start-up of the device /
electric shock
Unintentional start-up of the suction motor
can cause injuries. Voltage present on
electrical parts can cause an electric shock.
Switch off the device and unplug the mains
plug before performing any work on the de-
vice.
English