2
1
10. Then refit the bracket cover.
Fitting the plinth
Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make a
cut out as shown.
170-220 mm
900 mm
30-100 mm
• If using a plinth higher than 100 mm but
less than 140 mm, cut the height
compensation strip supplied with the
appliance to the required depth and fit it
between the plinth and the ventilation
grille, pressing it into position below this
grille.
• If using a 100 mm plinth, fit the
complete height compensation strip.
3
820-870 mm
140-190 mm
140-190 mm
1
2
Alignment height of 870 mm
• If using a 190 to 220 mm plinth, make a
cut out as shown.
30-100 mm
• If using a plinth higher than 150 mm but
less than 190 mm, cut the height
compensation strip supplied with the
appliance to the required depth and fit it
between the plinth and the ventilation
grille.
• If using a 150 mm plinth, fit the
complete height compensation strip.
• If the appliance is installed at the end of
a row of units, insert foot E to hold the
plinth in place.
17
3
100-150 mm