Items Supplied; Unpacking; Before Using For The First Time - Silvercrest SSC 200 A1 Bedienungsanleitung

WARNING! Risk of material
damage
Never operate the slow cooker without wa-
ter. This could cause it to overheat. For the
same reason, never operate the slow cook-
er without the cooking pot 3 in place.
The lid 1 and cooking pot 3 ...
... are fragile. Handle them carefully.
... may crack if exposed to sudden tem-
perature changes. So allow both to
cool before immersing them in water.
... are not suitable for roasting, or for
use in ovens, microwaves, freezers
or food warmers.
The appliance and accessories may not
be put in a microwave oven.
If you serve the finished dish in the hot
cooking pot 3, place a heat resistant ta-
ble mat underneath it to prevent mark-
ing the table top.
Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
Only use the original accessories.
The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have ingredients that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 base 5
1 ceramic cooking pot 3
1 lid 1
1 operating instructions

Unpacking

1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
6
GB
5. Before using for the
first time
FIRE HAZARD! Before turning the
device on, place it on a level, sta-
ble, dry, heat-resistant surface.
DANGER! Risk of injury
through burning!
The surfaces of the device become
very hot during operation. While
the device is in operation, only
touch the control knob 7, lid han-
dle 2 or device handles 4.
NOTE: as the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time
it is used. This is not harmful and will stop af-
ter a short while. Please ensure adequate
ventilation during this process.
• Clean the appliance before using
it for the first time (see "Clean-
ing" on page 11)!
1. Place the appliance on a level, dry,
non-slip surface so that the appliance
can neither fall over nor slide off.
2. Stand the cooking pot 3 in the base 5.
3. Pour half a litre of water into the cook-
ing pot 3.
4. Place the lid 1 on the cooking pot 3.
5. Insert the plug into a suitable earthed
socket.
6. Turn the control knob 7 to the setting
"HIGH".
7. The indicator light 6 will come on and
the appliance will begin heating up.
8. Allow the appliance to operate switched
on for approximately 60 minutes.
9. Switch the appliance off by turning the
control knob 7 to "OFF".
10. Disconnect the mains plug.
11. Let the appliance cool down and then
clean it again. The appliance is now
ready to use.