Unpacking And Setting Up; Items Supplied - Silvercrest SFPM 600 A1 Bedienungsanleitung

Note the information in these user in-
structions on the maximum filling vol-
umes, maximum ingredient quantities,
maximum operating times and the rec-
ommended speed settings.
Do not overfill the blender jug and the
working container, otherwise the con-
tents may be ejected. Overflowing liq-
uid would flow onto the surface. You
should therefore place the device on a
waterproof surface.
Do not exert too much pressure on the
grater and cutting disc. Apply an even
pressure so that the motor does not be-
come blocked.
Do not operate the device when it is
empty, as this causes the motor to over-
heat and may result in it becoming dam-
aged.
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.
The device is equipped with non-slip
plastic suction feet. As furniture is coat-
ed with a wide array of varnishes and
plastics and is also treated with different
care products, it cannot be fully ruled
out that some of these materials contain
ingredients that could attack and soften
the non-slip plastic suction feet. If neces-
sary, place a non-slip mat under the de-
vice.
Never fill the blender jug with hot or
boiling material.

4. Items supplied

1 multifunction food processor, base
unit 12
1 axle 9
1 adapter 7
1 working container 8 with
- lid 3
- food pusher 1
1 whisking disc 17
1 mixer assembly 4
34 GB
1 blade assembly 5 with blade guard 6
1 grater and cutting disc 16
1 blender jug 13 with
- lid 14
- mini measuring cup 15
1 copy of the user instructions
5. Unpacking and
setting up
NOTE: when the device is used the first few
times, some odour may be generated by the
device due to the heating of the motor. This
is harmless. Please ensure adequate ventila-
tion.
1. Remove all packing material.
2. Check to ensure that all parts are pres-
ent and undamaged.
3. Clean the device prior to first
use! (see "Cleaning and servicing the
device" on page 46).
4. Figure A: wind the excess power ca-
ble 10 around the cable spool 20 on
the underside of the base unit 12 and
fix it in the cable clamp 19.
5. Place the base unit 12 on a level, dry
and waterproof surface, so that the de-
vice can neither fall nor slip off.
Select a smooth, clean surface, so that
the suction feet 18 can stick firmly in
place and ensure a secure grip.
CAUTION:
Overflowing liquid would flow onto the
surface. You should therefore place the
device on a waterproof surface.