Herunterladen Inhalt Inhalt Diese Seite drucken

Warranty - Dometic MoBar300S Bedienungsanleitung

Getränkebar
Vorschau ausblenden Andere Handbücher für MoBar300S:
Inhaltsverzeichnis

Werbung

Warranty

Problem
Device is not cold enough.
Device switches itself on
and off.
The light does not work.
The device seems to make
a lot of noise.
The door does not close
properly.
LED indicates E1, E2 or E7.
11
Warranty
The statutory warranty period applies. If the product is defective, please contact your retailer or the manufacturer's
branch in your country (see dometic.com/dealer).
For repair and warranty processing, please include the following documents when you send in the product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or nonprofessional repair can have safety consequences and might void the warranty.
28
Possible cause
Temperature not set properly
Ambient temperature could require a
higher temperature setting
Door opened frequently
Door not closed properly
Door not hermetically-sealed
The cabinet recently replenished with
new bottles
Door opened frequently
Door not closed properly
Door not hermetically-sealed
Device not connected to a power supply
Circuit breaker or fuse blown
Light switched off on the control panel
The noise is probably caused by the refrigerant, which is normal. At the end of
each cycle, you will hear noises made by the flow of refrigerant.
If temperature fluctuations occur, the contraction and expansion of the inner walls
may cause popping and cracking noises.
High ambient temperature leads to constant operation of the compressor which
can lead to a lot of noise.
Door seal dirty
Shelves are not fitted correctly
Temperature sensor for the fan inside the
device shows an error
MoBar300S/550S
Remedy
Check the set temperature.
Set a higher temperature.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Leave the device to work for a while
until the set temperature has been
reached.
Do not open the door more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Connect the device.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Clean the door seal.
Check the shelves and refit cor-
rectly.
This can only be repaired by an
authorized repair center.
EN

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mobar550s

Inhaltsverzeichnis